No Heat?
Get a clear answer on whether repair or replacement makes financial sense, before any work is booked.
What Goes Wrong
A fast fix that skips the root cause leaves you calling again before the season ends.
Replacing one part without testing the full system often leaves a second fault undetected until the next cold snap.
Every visit tests the igniter, flame sensor, blower motor, and control board before any part is quoted or ordered.
A cracked heat exchanger is a carbon monoxide risk; skipping that inspection treats a safety issue as a deferred repair.
Older units and any combustion symptom trigger a heat exchanger inspection as a standard part of the diagnostic visit.
Spending on a repair for a furnace past 20 years often leads to another breakdown within one or two heating seasons.
The written estimate covers both repair and replacement scope so you can compare costs against the unit’s remaining useful life.
Getting only a repair quote means you have no basis for comparison if the repair cost is close to replacement cost.
When repair cost warrants it, the estimate includes a replacement option with equipment, installation, and timeline side by side.
What We Cover
From a single failed part to a full system swap, the scope depends on what the diagnostic finds.
A licensed technician tests the igniter, flame sensor, heat exchanger, and controls to locate the fault before quoting any repair.
Single-part failures, blower motor, draft inducer motor, gas valve, or control board, repaired with the full system retested after.
Old unit removed, new altitude-adjusted system installed, and a post-install performance check completed before the technician leaves.
Test, clean, or replace the igniter and flame sensor.
Diagnose and replace a worn or failed blower motor.
Visual and combustion test for cracks or leaks.
Swap a failed board and verify all system functions.
Test and replace a faulty gas valve safely.
Confirm the thermostat is reading and signaling correctly.
Why Choose Us
Process and accountability that keep the repair-or-replace decision in your hands, not ours.
Every quote lists equipment, labor, and timeline separately, no line items added after the visit.
When repair cost warrants it, you receive repair and replacement scopes side by side to compare directly.
Replacement units are sized for Denver’s elevation, an undersized furnace will short-cycle all winter.
After every replacement, a final check confirms the system heats to spec before the technician leaves.
We connect you with licensed independent technicians who carry the right credentials for gas furnace work in Colorado.
How It Works
01
Tell us the symptoms, no heat, short cycling, odd noise, and we arrange a licensed local technician to visit.
02
The technician runs a full diagnostic and delivers an itemized estimate covering repair or replacement before any work starts.
03
Once you approve the scope, the work is completed and a post-install check confirms the system performs as specified.
Pricing Estimates
| Job | Typical cost | Typical size |
|---|---|---|
| Furnace repair | $150-$600 | Standard service |
| Furnace component repair | $300-$1,200 | Parts and labor |
| Standard furnace install | $2,500-$6,500 | Residential home |
| High-efficiency furnace install | $3,200-$5,500 | Residential home |
| Furnace and AC replacement | $10,000-$19,000 | Whole-system project |
Describe the problem and we will arrange a licensed local technician to assess the system and give you a written estimate before anything is booked.