Zone Comfort
Quiet, year-round heating and cooling for any room, no ductwork needed, no window unit compromise.
What Goes Wrong
The difference between a system that performs and one that frustrates usually comes down to sizing and line routing decisions made before installation.
An undersized unit runs constantly without reaching setpoint; an oversized one short-cycles and leaves the room humid.
A load check accounts for room dimensions, insulation, ceiling height, and Denver’s elevation before equipment is selected.
A cooling-only unit leaves you without a heating source when Front Range temperatures drop below freezing in shoulder months.
Cold-climate heat pump models maintain output at low outdoor temperatures, covering both seasons from one wall-mounted head.
Refrigerant lines run too long or with too many bends lose pressure, reducing efficiency and shortening compressor life.
The line set route is mapped before installation to keep copper tubing runs direct and within manufacturer length limits.
A system put into service without a refrigerant pressure test can leak slowly, losing capacity before the problem is noticed.
Every installation includes a refrigerant pressure test and full function check before the job is signed off.
System Options
From one hard-to-condition room to a whole floor without ductwork, the right configuration depends on zone count and how you use the space.
One outdoor condenser paired with one wall-mounted air handler, the straightforward fix for a single room or addition.
One outdoor unit connected to up to four or five indoor heads, each controlled independently for room-by-room temperature.
Heat pump models provide both heating and cooling from the same unit, rated for year-round use through Denver’s seasonal swings.
A flush-mounted ceiling cassette distributes air in four directions, a cleaner look where wall mounting is not practical.
Copper lineset run from outdoor unit to each indoor head.
Dedicated circuit and disconnect box for the outdoor condenser.
Wall bracket, insulated tubing, and condensate drain fitted.
Pressure test, function test, and thermostat calibration.
Why Us
Every job starts with a proper assessment and ends with a documented check, not a rushed install and a handshake.
Denver’s elevation is factored into the load check so BTU capacity is correct before any equipment is ordered.
The written estimate covers equipment, installation scope, and timeline, no line items added after the visit.
A refrigerant pressure test and full function check are completed before the job is signed off.
We connect you with licensed local technicians who carry the right certifications to handle refrigerant and electrical work.
The load check determines how many zones you actually need, we do not add heads to inflate the scope.
The Process
01
Tell us the space, its size, and whether you need heating, cooling, or both, and we arrange a licensed local technician to visit.
02
The technician completes a load check and delivers an itemized written estimate covering equipment, line routing, and electrical work.
03
The system is installed, the refrigerant line set is pressure-tested, and a function check confirms performance before the technician leaves.
Pricing Estimates
| Job | Typical cost | Typical size |
|---|---|---|
| Single-zone mini-split install | $2,000-$5,000 | Per zone |
| Multi-zone mini-split install | $6,000-$15,000 | Whole home |
| Mini-split replacement | $3,000-$8,000 | Existing location |
| Mini-split repair | $150-$900 | Service call |
Describe the space and we will arrange a licensed local technician to assess it, size the system correctly for Denver’s conditions, and deliver a written estimate before anything is booked.